Installation, Operation and Maintenance of Vibrating Feeder in Fote

Broken production line of vibrating feeder of the installation points three conditions:Level installation. This type of installation is generally applied to materials uniform stable feeding. It can prevent their material. Slope down10 degrees. This type of installation is used in general raw material continuously feeding.Slope downward 15 degrees. This type of installation is applicable to viscous or large water raw material continuously of feeding. Vibrates the feeding stimulus should be paid attention to during the situation:Always check the amplitude of vibration motor, if discovery is unusual, shall be immediately stop. This is because of the vibration motor current and motor surface temperature requirements, not even before and after the amplitude about wave set.When running two sets of vibration motor must reverse spin. If current appear unstable or a loudly noise, should stop soon. Vibrates the feeding machine maintenance: Run before all bolts should be a vibration motor, especially the anchor bolt, continuous operation 3-5 hours should be retightened once.Motor bearing is the broken production line of vibrating feeder mouth key equipment, so for its maintenance especially important also. The simple case every 2 months filling the lubricating oil, high temperature season every month should be filling the lubricating oil.Our effective vibrating feeder machien could be applied to series of construction companies. For instance, the cement factories and building companies would need to use it to accomplish completed tasks. It enable the customers to earn more profits since the energy consumption is reduced. During the researching and manufacturing, Fote Machinery believe that we should connect our designs with the market demand.swing feeder: http://www.china-ftm.com/pros/pendulum%20feeder.html